Create, Dare, Be Passionate!
500ml Water Bottle Cuff
19,95 € 16,62 €
Availability: Out of stock
SKU
ZBO_500mlBottleWrap
This sleeve allows you to perform sublimation transfers on 500ml water bottles. It can be used in a conventional convection oven or a 3D oven. This gives you the ability to easily sublimate the entire surface of your bottle. It securely holds the image on the bottle for an efficient and high-quality transfer. Its silicone material and metal coating are designed to withstand extreme temperatures.
This sleeve will allow you to offer a wider range of products to your customers.
Don't wait any longer and adopt this new sublimation accessory! You'll be impressed.
Creadhésif Tip: Use high-temperature tape to securely attach your printed design to your water bottle before attaching the sleeve. Leave your water bottle in a convection oven at 200°C (390°F) for 8 minutes.
Technical Specifications:
Materials: metal and silicone
Dimensions: Ø 7.3 cm, H 20 cm
Sold individually
Thanks to the 3D oven, you can easily enhance your creations in 4 steps:
1. Attach your printed design to the mug with the high-temperature tape and secure the sleeve around the mug
. 2. Lock the oven lid and connect the air extraction cable to the lid.
3. Activate the air pump.
4. Close the oven, preheated to 200°C (390°F), and set the timer.
Sublimating one mug takes 360 seconds (6 minutes), and sublimating 12 mugs takes 480 seconds (8 minutes).
Write your own review