Digicoat opaque white - dark surface

This product is strictly prohibited for delivery BY AIR to French overseas departments and territories and internationally. Any material or merchandise considered dangerous is prohibited in the hold or cabin (example: all gas cylinders, industrial lacquers, varnishes or paints, and chemical products).

Opaque white Digicoat allows you to apply a white undercoat to dark surfaces in preparation for sublimation, such as a piece of slate or other similar material.

For sublimation to be successful, your surface must be white or close to white to give your image depth.
To prepare your surface for sublimation, first apply opaque white Digicoat, then transparent Digicoat. Opaque Digicoat has been specially designed for use with transparent Digicoat.

It is easy to apply and can be used on many substrates. It will not flake or discolor in the heat.
With opaque Digicoat, you can now sublimate a wide variety of dark surfaces.

for use Instructions :
1. Shake well for 1 minute.

2. Ensure the surface to be coated is clean, dry, and free of grease.

3. If your surface has a glossy finish, it is recommended to use the adhesion pre-treatment Digicoat.

4. For best results, apply the opaque Digi Coat from a distance of approximately 25 cm from the surface.

5. Allow to air dry for 5 minutes, then bake in an oven at 160°C for 15-20 minutes.

Caution: Aerosol products cannot be transported by air.