Create, Dare, Be Passionate!
UniPrint A Printable Flex - Matte Finish 50 cm x 25 m
149,90 € 124,92 €
Availability: Out of stock
SKU
CFP_301A_50x25M
This 80-micron thick printable flex material is compatible with solvent and eco-solvent printers (including TrueVIS and Latex). Its white, water-based polyurethane film is solvent-free and PVC-free, allowing you to work on a variety of materials: cotton, polyester, polycotton, acrylic, and coated nylon/polyester. It is recommended for sportswear, luggage, umbrellas, and promotional products.
The matte backing prevents the film from slipping on the rollers during printing. Durable and elastic, this product can be machine washed up to 60°C (except for nylon) without wrinkling.
This will allow you to create crisp, colorful visuals according to your ideas. This heat transfer vinyl will quickly become your ideal partner for all your productions!
Caution! It is essential to perform tests on nylon . The characteristics of nylon can vary depending on its color, finish, etc
:Product Advantages - -
Matte finish
- Easy and precise weeding, even for small letters
In case of slight lifting of letters during weeding, replacement is possible
- Energy and time saving
- Adheres to a wide range of fabrics including nylon
- Wash resistant and elastic
- Does not wrinkle after washing
- 100% made in France
- Environmentally friendly (water-based formula, solvent and PVC free)
Roll dimensions: 25 m x 50 cm
Créadhésif Tip: Fortransfers onto nylon (polyamide) fabrics, first press at 150°C for 20 seconds and slowly peel the transfer tape off the hot surface. Then, press a second time, protecting your surface with baking paper, at 150°C for 10 seconds. Maximum washing temperature: 40°C.
Technical Specifications:
- Composition: very slightly adhesive polyester
- Outer layer: Aqueous polyurethane, white, opaque, solvent-printable, eco-solvent.
- Inner layer: Heat-sealable copolymer, matte finish
- Adhesive backing thickness: 110 microns
- Total thickness: 100 microns
- Heat-sealable polyurethane thickness: 80 microns.
Instructions for use:
Pressure without overlapping: Recommendations for all fabrics (except nylon)
1. If using a new fabric, perform preliminary tests.
2. Print and cut in positive using solvent or eco-solvent ink.
3. Transfer onto fabric using one of our UNITAPE application tapes, protected by baking paper.
Press at 140 degrees for 10 seconds.
Washing temperature: 60°C
Instructions for use:
- Carefully follow the instructions specified on the garment.
- Wait 24 hours before the first wash. Do not use harsh detergents.
- Iron inside out only
. - Store the product in a temperate, dry place, away from direct sunlight.
- It is essential to use the official printer ink.
Washing temperature:
- Standard textiles: 60°C
- Coated nylon: 40°C
Write your own review