White Plastisol adhesive for screen printing transfers: Ready to use

Preparation:
Ready-to-use adhesive. It is necessary to mix the ink thoroughly before use.
We recommend using Amex SCREEN SOL QT BLU as a photo-emulsion.

Application:
Printing is required on a screen with a maximum resolution of 34 threads/cm on a sheet of silicone-coated paper.

Drying:
The transfer dries at 120-130°C for a maximum of 60-90 seconds.
It is important to carefully monitor the drying temperature to ensure complete hardening of the ink.
Conversely, excessively high temperatures or prolonged drying times will alter the adhesive properties.

Transfer application:
170/180 °C for 12 to 15 seconds. Pressure: high, 4 bar.
For successful transfer, perform a cold peel.

Cleaning:
Wash the tools with a solvent.

In the case of making multicolour screen printing transfer sheets, you must first apply your plastisol inks one after the other, proceed to drying between each colour (120°C-130°C for 60 to 90 seconds), then finish by applying your layer of white adhesive glue (120-130°C for 60 to 90 seconds).

Your screen for applying the adhesive should be slightly larger than your image.
To improve the elasticity and mechanical resistance of your transfer, you can apply a first coat of transparent ink.
Finally, to further enhance the adhesion of your transfer, you can add hot melt powder.